23 Sept 2026 · 5 min read
How to Prepare Artwork That Embroiders Cleanly
Embroidery reproduces shapes with stitches, so a file that prints perfectly can still fail as a patch. The fix is usually simplification, not a different supplier.
Start from vector, not a screenshot
An AI, PDF or EPS file lets the digitiser see the construction lines and adjust stitch direction. A low-resolution PNG forces redrawing, and small details get interpreted rather than reproduced.
Respect the minimum text size
Below roughly 4 mm, letters lose their counters and read as blocks. If the text is essential, either enlarge the patch or move that line to a woven label, which holds finer detail.
Reduce colour transitions
- Gradients become stepped thread blends; confirm the closest three or four shades on the mockup.
- Thin outlines under 1 mm may disappear between stitch rows.
- Very small isolated details, such as stars or dots, are better merged into the background.
Choose backing before sampling
Iron-on backing needs a heat-press test on the actual garment fabric. Sew-on is the durable choice for uniforms washed repeatedly. Hook-and-loop suits kits where patches are swapped between garments or bags.
Check the border
A merrowed border adds a raised stitched rim and needs extra space around the artwork. A laser-cut border follows the shape closely and looks cleaner on geometric designs. Decide this before the die or cut file is prepared.
In short
Send vector artwork, keep text above 4 mm, reduce gradients, and choose the backing and border in the same message. Those four points remove most sample revisions.