Skip to content

Craft options

Six finishes, and where each one actually fits

Craft decides how a logo reads at small size, how the piece wears, and how much of the budget goes to finishing rather than material. These notes explain the trade-offs we review with buyers.

01

Soft Enamel

Recessed enamel with raised metal lines, the most requested finish for corporate pins.

  • Lapel pins
  • Keychains
  • Fridge magnets

Colour is filled below the metal edge, so the outline stays visible and the surface reads slightly textured. It suits detailed logos, small text and tight budgets.

Note: Pantone matching available; plating in gold, silver, nickel, black or antique finishes.

02

Hard Enamel

Polished flat surface with colour and metal at the same level.

  • Executive gifts
  • Anniversary pins
  • Premium keychains

The piece is filled, then polished flat, producing a smooth jewelled surface. Small text and fine lines survive better than in soft enamel, and the finish reads more premium.

Note: Higher unit cost than soft enamel; best for short text and simple shapes.

03

3D Relief

Sculpted metal with multiple levels, used for landmarks, mascots and shaped pieces.

  • Mascot pins
  • Landmark pieces
  • Collector items

A mould is cut to create depth beyond a single stamping level. Relief pieces carry dimension without relying on colour, which suits architectural and character-based designs.

Note: Requires a mould; artwork needs clear front, side and depth references.

04

Epoxy Coating

A clear dome over the enamel that protects colour and adds gloss.

  • Keychains
  • Printed pins
  • Giveaway items

Epoxy is applied over a printed or enamel base. It protects against abrasion and moisture, and is common on keychains that see daily handling.

Note: Adds a slight thickness; not recommended where a flat stack is required.

05

Embroidery

Thread-based patches in flat, 3D foam and high-density constructions.

  • Uniform patches
  • Club and event badges
  • Brand merch

Flat embroidery keeps a low profile; 3D foam lifts selected areas; high-density stitching covers more of the base fabric for finer detail. Backing can be iron-on, sew-on, hook-and-loop or adhesive.

Note: Gradient colour is reproduced with thread blends; very small text should be simplified.

06

Laser Engraving & UV Printing

Cut acrylic shapes with engraved or UV-printed graphics.

  • Acrylic awards
  • Table signs
  • Retail displays

Laser cutting defines the silhouette and edge polish; engraving creates a frosted mark inside the material, while UV printing lays colour on the surface. The two are often combined on awards and signs.

Note: Thickness and edge finish are confirmed per design; no metal mould is required.

Craft by product line

CraftEnamel giftsPatchesAcrylic
Soft EnamelBest fitNot applicableNot applicable
Hard EnamelPremium optionNot applicableNot applicable
3D ReliefShaped / mascotFoam versionNot applicable
Epoxy CoatingPrinted pinsNot applicableOptional gloss
EmbroideryNot applicableBest fitNot applicable
Laser / UVEngraved backsWoven labelsBest fit

Share your logo and ideas

Send artwork, quantity and destination. We reply with a free 3D mockup and a formal quotation within 24 hours on business days.

Get Free 3D MockupChat on WhatsApp

sales@shineloop.asia · +86 187 2098 9159